COVANA C-HOR, Инструкция по эксплуатации

Страница: 38 / 60

38 INSTALLATION INSTALLATION MANUAL
Tub mounting
Note: If the cover was supplied with the ground
anchoring option, skip to the ground anchoring
mounting section .
1) Ensure the system is well positioned around the
hot tub and the cover is lying flat and centered
on the hot tub.
CAUTION
•
It is important to verify that the assembly is
well centered and positioned before mounting
it. Failure to follow this instruction will cause
permanent damage to the hot tub.

Use a 24 in. (61 cm) level to ensure both post
assemblies are perfectly straight.
Note: Regardless of the tub size, the tub mount
arms need to be mounted to the tub using the
provided tub mount supports. Depending on the
tub size, long, short or both tub mount arms
might be used. The angle at which these arms
will be fastened also depends on the size of the
hot tub.
2) Depending on the height and the width of the hot
tub, fasten the arms (either short or long arms)
to the sleeve brackets using 1/4-20 x 5/8 in.
carriage bolts, 1/4-20 hex nuts and 1/4 lock
washers. Keep these loose for now. (Figure 88)
3) If
the arm still doesn’t reach the skirt of the hot
tub, add the other tub mount arms and fasten
them with 1/4-20 x 5/8 in. carriage bolts, 1/4 flat
washers, 1/4 lock washers and 1/4-20 hex nuts.
Keep these loose for now. (Figure 89)
Note: Adjust the angle of the arms so the top tub
mount supports are as close to the acrylic as
possible, but without touching it, and the bottom
mount supports are as close to the bottom of the
tub as possible.
4) Install the tub mount supports on the arms. If it is
possible, fasten the tub mount supports to the
absolute extremities of the arms. Use 1/4-20 x
5/8 in. carriage bolts, 1/4 lock washers and 1/4-
20 hex nuts. (Figure 90)
1/4 flat
washer
Short tub
mount arm
Long tub
mount arm
1/4-20 x 5/8
in. carriage
bolts
1/4 lock
washer
1/4-20
hex nut
Figure 89
Figure 90
Tub mount
long arm
Tub mount
support
1/4-20
hex nut
1/4 lock
washer
1/4-20 x 5/8 in.
carriage bolts
1/4-20 x 5/8
in. carriage
bolts
1/4 lock
washer
1/4-20
hex nut
Tub mount arm
(long arm shown)
Figure 88