COVANA C-HOR, Инструкция по эксплуатации

Страница: 23 / 60

INSTALLATION MANUAL INSTALLATION 23
11) Unscrew the top #8-10 x 1½ in. Robertson
screws holding the posts to the crate as shown
in Figure 36.
12) Remove both post assemblies from the crate and
place them in a safe place.
WARNING

The post assemblies are heavy. Two people
might be needed to perform this.
13) Remove the post support brackets by
unscrewing the #8 x 1/2 in. Robertson screws on
each bracket (two support brackets per post).
(Figure 37)
14) With the help of another person, lay the crate
horizontally on its back. There should be one
person on each side of the crate. (Figure 38)
WARNING

The crate is heavy; you may require a third
person to rotate the crate.
15) Remove the stud over the part boxes and the
other components by unscrewing the #8-10 x 1½
in. Robertson screws on both sides of the crate.
(Figure 38)
16) Remove the part boxes and store them in a safe
place.
17) Cut the tie-wrap holding the I beam and the C-
channels on the middle 2 x 3 in. stud, remove
them from the crate and store them in a safe
place. (Figure 39)
18) Remove the two studs holding the fiberglass
panels in the crate. (Figure 39)
19) Leave both fiberglass covered foam panels in the
crate until they are needed. (Figure 39)
WARNING

The panels are fragile, handle them with care
so as to ensure that they are not scratched or
damaged.
Figure 38
Figure 36
#8-10 x 1½ in.
Robertson screws
Figure 39
I-beam
C-channels
Part boxes
Fibreglass
panels
= Stud screws
location
Figure 37
#8 x 1/2 in.
Robertson
screws