COVANA C-HOR, Инструкция по эксплуатации

Страница: 34 / 60

34 INSTALLATION INSTALLATION MANUAL
Figure 76
5) Place the motor-side along the rear of the cover
with each end close to the two square drive-
shafts that were installed previously. (Figure 76)
CAUTION
•
Ensure the input shaft in the middle of the U
frame is pointing outwards from the cover.
(Figure 76)
•
Ensure the keyway of the motor-
side’s input
shaft is pointing upwards.
6) Slide the open end of the left square drive-shaft
over the square shaft located at the end of the
motor-side. (Figure 76)
CAUTION
•
Do not pull on the drive shaft, otherwise it will
slip off the jack.
Note: You might need to rotate the output shaft
of the motor-side assembly so both output shaft
and drive shaft align with each other.
CAUTION
•
Do not turn the shaft more than a 1/8
’’
[3.175
mm] of a turn. Failure to follow this instruction
might break components from the post
assemblies.
7) Repeat step 6 for the right side.
8) Be sure that the holes on the short U-frame are
aligned with those on the long u-frame corner
bracket. (Figure 77)
9) Be sure that everything is locked in place by
sliding a 5/16-18-2 hex cap screw with a 5/16
nylon washer through each of the two holes of
the short U-frame and put a 5/16-18 hex lock nut
from the other side of each bolts. (Figure 77)
CAUTION
•
Do not overtighten the bolts or use any power
tools as it could damage the U-frame, the paint
or the hardware itself.
5/16-18 x 2 in.
hex cap screw
5/16 x 18 in.
hex lock nut
Short U-frame
Long u-frame
Corner bracket
Motor-side
Motor-
side’s
input shaft
5/16 Nylon washer
Figure 77