PAGE 7 OF 7
Please read the following switch usage instruction for lighting and to
extinguish:
Switch Usage Instruction
Step 1: Lighting :
To ignite, push the “T” shaped switch in and rotate
counterclockwise. Release the switch after lighting
and when the flame is stable.
Step 2: Adjusting :
When lit, let the “T” shaped switch pop up, wait 5
seconds, and rotate the switch counter-clockwise
to adjust the flame size.
Note: To extinguish the flame, push the “T” shaped switch in and rotate clockwise.
OFF
PILOT
ON
MAX
MIN
Main Flame
Yellow
Blue
Incorrect
Flame
correct
Flame
Very hot while in operation!
Never lean over the fireplace while in use.
Do not touch tile of spark guard while the fire pit is in operation, wait until
the fire pit has cooled down after use.
Failure to comply with these instructions may result in
serious bodily injury.
Instructions for lighting and shutting down
appliance:
1. Read the instructions before lighting and shutting down the appliance.
2. Turn the Tee handle to OFF position.
3. Fully open the gas control valve.
4. Push and rotate the tee handle counter-clockwise, hold it at the pilot
position for at least 20 seconds until the thermocouple is hot. Do not
stand with your head or arms over the fire pit.
5. If ignition of the pilot does not occur in 5 seconds, turn off the tee handle,
wait for 5 minutes, and then repeat the lighting procedure.
6. Keep rotating the tee handle slowly to open the burner.
7. Rotate the tee handle clockwise to shut down the fire pit.
Step 3
Step 4
CARE AND MAITENANCE:
1. Do not use aerosol polish or any other flammable material to clean the
burner while it is in use.
2. Inspect and clean the burner regularly. Use a wire bristle brush to clean
the burner surface. A straightened paper clip is useful to remove debris or
rust from the small burner ports.
3. Wash frame parts with mild soap and water, rinse thoroughly, and dry
frame completely. Do not use bleach, acid, or any other solvents on the
frame parts.
4. Please inspect and tighten all of the bolts and fasteners on a regular basis
to ensure proper performance and safety of your outdoor firepit.
5. When not in use, we recommend that it be stored in a dry and secure area.
Always disconnect the LP gas tank first and store it safely outside.
6. The minimum clearance from the sides and rear of unit to adjacent
combustible construction: 2 feet from sides and 2 feet from rear.
WARNING
!
Use of your fire pit causes carbon
residue to build up on the lava rocks
inhibiting the airflow and leading to
a more yellow flame. Stir up the lava
rocks regularly to remove these
deposits and maintain a blue flame.
LP GAS SAFETY INSTRUCTIONS
This outdoor fire pit is not intended to be installed in or on
recreational vehicles and/or boats.
1. Never connect an unregulated LP gas tank to your fire pit. The
gas regulator assembly supplied with your fire pit is adjusted to
have an outlet pressure of 11’’ water column (W.C.) for
connection to an LP gas tank.
2. Only use the regulator with hose assembly supplied with your
fire pit. A replacement regulator with hose assembly must be the
one specified in this manual.
3. Have your LP gas tank filled by a reputable propane gas dealer
and visually inspected and re-qualified at each filling.
4. Never fill the gas tank beyond 80 percent full. Have your
propane gas dealer check the release valve after every filling to
ensure that it remains free of defects.
5. Always keep LP gas tanks in an upright position. Do not store
(or use) gasoline or other flammable vapors and liquids in the
vicinity of this appliance.
6. LP gas tanks not connected for use must NOT be stored inside
of the fire pit or in the vicinity of this or any other gas appliance.
7. Do not subject the LP gas tank to excessive heat. Never store
an LP gas tank in a garage or any other indoor location. Always
disconnect the LP gas tank first and store it safely outside.
8. LP gas tanks must be stored outdoors in a well-ventilated area
and out of children’s reach. Disconnected LP gas tanks must not
be stored in a building, garage, or any other enclosed area.
9. When your fire pit is not in use, the gas must be turned off at the
gas tank.
10. The regulator with hose assembly should be inspected before
each use of the fire pit. If there is excessive wear, any abrasions,
or if the hose is cut, it must be replaced prior to use of the fire
pit.
11. Keep the gas regulator hose away from hot surfaces. Avoid
unnecessary twisting of the hose. Visually inspect the hose for
cuts, cracks, excessive wear, or damage prior to each use of
the fire pit. If the hose is damaged DO NOT use the fire pit.
Call 1-877-539-7436 for an authorized replacement hose.
12. Never allow children to play near your fire pit.
Maximum Inlet Pressure 250 psig
Minimum Inlet Pressure 25 psig
Manifold Pressure 11 inches W.C.
Gas Rating 37,000 BTU/hr
TYPES OF GAS LIQUID PROPANE