Cotech HY3315A1, Руководство пользователя

Страница: 10 / 52

10
EN
G
LI
SH
9. Maintenance
Warning! Disconnect the sparkplug lead before carrying out any maintenance.
A. Locking cap
B. Spool
C. Spring
D. Spindle
E. Housing
F. Line slot
G. Line hole
H. Trimmer line
9.1 Changing the trimmer line
1. Turn the locking cap (A) anticlockwise and remove it (either by hand or using the spanner
supplied).
2. Remove the spool (B) and the spring (C) from the spindle (D).
3. Remove the existing trimmer line (H).
4. First measure, then cut a 8.6 metre length of trimmer line (Ø 2 mm). Fold it in the middle
so that you have two ends measuring 4.3 metres. Place the middle of the fold in one of the
slots in the disc dividing the spool See fig.17.
5. Wind both ends of the line onto the spool, clockwise as shown in fig. 18. Hold the line in
your fingers so that it is taught as it is wound on, stop when roughly 15 cm of the line ends
remain.
6. Press the ends of the line into the slots on opposite sides of the spool as fig.19 shows.
7. Push in the spring (C) on the bottom of the spool (if it is not already secure). Pull the ends
of the line through the holes (G) in the side of the housing (E). See fig. 20.
Fig. 16
.
Fig. 17
.
Fig. 18
.
Fig. 19
.
Fig. 20
.