Cosmos XP-3180, Инструкция по эксплуатации

Страница: 16 / 32

− 14 −
Operating Procedure
■
Logging
Take the following steps to log the detected gas.
(1) Press the MENU switch for three seconds while the gas
concentration screen is displayed to display the logging
start screen. Refer to page 11.
The bar graph shows the rough possible logging capacity
as a percentage. Refer to the operation manual of the Log
Data Collection Set for sampling cycle settings.
(2) Press the MENU switch to begin the logging start setting.
The 5 LG indication will then change from flashing to
steady illumination, and OFF will change from steady
illumination to flashing.
(3) Press the LIGHT switch (
▲
) to change OFF to ON.
(4) Press the MENU switch to enter the settings. The ON
indication will then change from flashing to steady
illumination, and 5 LG will change from steady illumination
to flashing.
(5) Press the POWER switch to return to the gas concentration
screen.
Make sure that the REC indicator is flashing.
To cancel logging, take steps similar to the above and turn
OFF the function.
The Gas Detector will stop logging if the Gas Detector is
turned OFF, or each error is displayed (see page 17), or
the memory capacity is low.
3. Operating Procedure (continued from previous page)
Note
Refer to the operation manual of the Log
Data Collection Set for details.
Flashes
Flashes
Press
SYMBOL.
Flashes
Flashes
Press
SYMBOL.
Press
SYMBOL.
Press
SYMBOL.
Logger capacity
Lit
Flashes