Cosco CEB TRIM-500E, Руководство пользователя

Страница: 12 / 15

11
b. Insert right Handlebar support (6R) to the right end of horizontal axle of Front upright frame (14) (the
long side of the handlebar face inside) and secure it with one Plastic flat washer (53),
Φ
8 Big washer
(49),
Φ
8 spring washer (51), M8 Special washer (16), and M8×20 Bolt (36).
c. After assembled the Nut cap (7) to the M8×20 Bolt (36 ), the right Handlebar support (6R) can move
freely.
7). Install the Pedal Support Tube (Left & Right)
Insert the left Pedal support tube (4) through the Rear U-shape bracket (35), put a Wave washer (28) and
Pedal axis bushing (54) into the Left pedal axis (30). And then attach the pedal axis (30) to the crank (67)
and tighten them with Power support pole (98) and then lock the left lock nut (43).
Do the same steps as above to assemble the right Pedal support tube (4) to the right pedal axis (31). (Refer
figure 7)
Note: The left & right screw thread should be fixed accordingly, and there is some labels stick on the parts:
left screw thread “L”, right screw thread “R”.
8). Install the Pedals
Attach the left Pedal (5) to the left Pedal support tube (4) with four M8x50 Bolts (37),
Φ
8 Flat washers (50),
and M8 Lock nuts (42). Do the same steps as above to assemble the right Pedal (5) to the right Pedal
support tube (4). (Refer figure 8)
9). Install the Handlebar (Left & Right)
Insert the Left handlebar (8) to the Left Handlebar support (6L) with
four sets of M8x40 Bolts (33),
Φ
8 Arc washers (45),
Φ
8 Spring
washers (51), and M8 Cap nuts (40). Do the above same steps to
assemble the Right handlebar (11) to the right Handlebar support (6R).
(Refer figure 9)
Note: The bolt must be set into the hexangular hole.
10). Install the nut cap