Cosco CEB TRIM-500E, Руководство пользователя

Страница: 10 / 15

9
6. Assembly Instructions
Attention:
1>. Please follow these assembly instructions step by step to assemble this elliptical bike.
2>. Before the bike leaving the factory, the plugs/pedals/covers, etc. are all fixed.
3>. Before using the bolts and nuts, please assemble them by hand firstly. After you finish assembling all
the parts together, please adjust them to the suitable position and fix them by using tools tightly.
4>. When you open the carton, please put the parts by different sorts. Then assemble it according to the
following pictures and parts list.
1). Install the Rear Stabilizer
Attach the Rear stabilizer (2) to the Main frame (1) with two sets of
M8×20 Bolts (38),
Φ
8 spring washers (51), and
Φ
8 Flat washers
(50).
(Refer figure 1)
2). Install the Front Stabilizer
Attach the Front stabilizer (13) to the Main Frame (1) with two sets
of M8×20 Bolts (38),
Φ
8 spring washers (51), and
Φ
8 Flat
washers (50). (Refer figure 2)
3). Install the Front Upright Frame
a. On the lower position of the front upright frame (14), there is
the tension control (21).Connect the joint of the tension control
(21) with the tension control wire (12) firmly. < Note: at first,
please turn the tension control’s knob to the bottom of the
“-“ direction (in this situation, the joint of the tension control will
be extended to the longest)>. Then put the end of resistance
cable into the spring hook of Tension control wire (12) as shown on drawing A of figure 3.
Pull the resistance cable up and force it into the gap of metal bracket of Tension control wire (12) as
shown on drawing B of figure3
Connect the resistance cable with the Tension control wire (12) completed as shown on drawing C of
figure 3. If the upper side of the tension control wire cannot fix perfectly in the gap of metal bracket,
please adjust the nut which below the bracket to the suitable position.