HomeVision® Pro/Lite
© Corroventa Avfuktning AB
Rev A
21 (30)
Default view and setup menus, Lite
Default view
In the default view, current crawl space relative
humidity and temperature are presented. The
indications in the lower part of the screen show, from
left:
•
Dehumidification, if the dehumidifier is
currently active or not. When active, the water
level in the droplet is moving and the outer
circle rotating.
•
Fan – if the fan is currently active or not. When
active the fan wheel and the outer circle are
both rotating.
•
Signal quality, how good the connection with
the Control Unit is. The higher the indication,
the better quality. When connection is lost, the
entire symbol flashes.
Please note that the signal quality reflects how
many data packages are correctly received in
their first transmission. The level normally
builds up over time and may then vary slightly.
Standard paired systems automatically
reconnect after power reset. When the Control
Unit has been powered down it takes
approximately three minutes for the system to
reestablish connection.
Administration menu
This menu is accessed from the default view by
pushing <Setup>.
To change parameters, push <Change>, use down
arrow to select parameter to change and push
<Select>.
Select parameter value of choice using the arrows and
then push <Save>.
Date is in the format YY-MM-DD.
”Connect new unit”
is normally only used at time of
installation. It shall be set to Standard which makes the
system automatically reconnect after power reset. The
Service alternative is only for use by service
technicians, establishing at temporary connection.
Service paired systems do not reconnect after power
reset. The Control Unit only allows pairing of new
Control Panel for two minutes after restart.
