corob EVOFLX-LW, Руководство пользователя

Страница: 39 / 45

- 37 -
COROB EVOFLX-LW
9 TECHNICAL SPECIFICATIONS
9.1 Technical information
(a)
Excluding connected auxiliary devices. The power information is purely indicative, and depends strictly on the
machine configuration. The machine serial number label indicates the exact power data, referred to the specific machine
configuration.
(b) Value measured in laboratory and documented by the corresponding test report available at the manufacturer's.
Operating conditions: machine normal working cycle, under simulated load conditions.
(c) The environment working conditions are strictly related to the type of colorants used (ask for information from the
paint manufacturer). The data shown are valid for the machine only.
(d) Hole diameter for pre-punched cans = flow di 15 mm (0.59"). The diameter may also vary based on the
partition of water/solvent circuits of the machine.
Power supply Single-phase 100 - 240V ±10%
Frequency 50/60 Hz
Fuses
(a) F 10 A
Max power absorbed
(a) from 70 to 600 W based on the configuration
Noise level (b) Level of equivalent acoustic pressure: <70 dB (A)
Environment working conditions (c)
Temperature: between 10°C (50°F) and 40°C(104°F)
Relative humidity: between 5% and 85%, without
condensation
Vibrations
The machine does not transmit vibrations to the floor
that may compromise the stability and precision of any
nearby equipment.
Canister capacity
1,5 - 2,5 - 5 liters
(1.58 q - 2.64 q - 1.32 G)
Number of canisters Up to 32
Dispensing technology
Hybrid: Bellow, BGP [bellow], DFP [piston] or in
combination
Nozzle center maximum flow diameter (d)
28 mm [up to 16c] - 39 mm [17-20c] - 45 mm [21-32]
1.1 in [up to 16c] - 1.5 in [17-20c] - 1.8 in [21-32]
Dispensing system
Sequential (default) /
Simultaneous /
Simultaneous On-demand
Dispensing center External
Type of canisters POM (Acetalic resin)
Type of valves
Electrovalves
Electrical/Pneumatic INV