STANDARD RECOMMENDED PROCEDURE 003-737 | ISSUE 4 | MAy 2015 | PAGE 8 OF 25
6.2 Mount the Enclosure into a Rack
Step 1:
Install the rack-mount brackets to each
side of the enclosure as shown in
Figure 7.
Step 2:
Using a hoist or lifting device, lift the
enclosure, position it within the rack
and secure the enclosure to the rack.
6.3 Mount the Enclosure on the Floor
IMPORTANT:
Pedestal must be used when floor
mounting the cabinet. The pedestal may be
attached to the cabinet with or without the
splice housing.
Pedestal Kit (p/n:IFDH-G3-PEDESTAL) comes
with:
• (1) Pedestal Assembly
• (4) #10 Washers (for securing the cabinet to
the pedestal)
• (4) #10-32 Self-locking nuts (for securing the
cabinet to the pedestal)
• (1) Isolation pad (installed between pedestal base and floor)
• (1) Ground wire
Step 1:
Determine the cabinet location in your application per the installation plan.
Step 2:
Determine the type of installation for floor mounting the pedestal. You will need to
order one of the following kits applicable to your type of installation:
• For mounting by drilling and installing wedge anchors, order p/n FDH-MTNG-KIT-
DRLAN
• For mounting to
precast inserts,
order p/n FDH-
MTNG-KIT-TDIN
• For mounting to
precast studs,
order p/n FDH-
MTNG-KIT-TDST
Step 3:
Use the base of
the pedestal as a
mounting template
as shown in Figure
8 to determine
the location of the
mounting holes.
Remove the front
access cover and
mark the holes
shown by the shaded
locations in Figure 8.
KPA-0738
Figure 7
KPA-1343
44.58 cm
(17.55 inch)
24.92 cm
(9.81 inches)
3.81 cm
(1.5 inch)
10.16 cm
(4 inches)
24.26 cm
(9.55 inches)
32.54 cm
(12.81 inches)
Figure 8
