Cornelius VIPER 3 FLAVOR, Руководство по установке

Страница: 11 / 36

Viper Installation Manual
© 2010-2016, Cornelius Inc. - 7 - Publication Number: 621360041TBINS
Figure 2.
S
UPPLY
C
ONNECTIONS
All of the electrical and supply connections to the unit are typically located near the bottom rear of the unit. There
are alternate locations for the electrical and supply connections on the bottom of the unit, below the rear
locations. The bottom connection locations may be used if the unit is located directly against a wall.
The electrical connection is located at the left side of the rear panel and the tubing supplies are located on the
right side, as shown in Figure 3.
Figure 3.
Electrical Requirements
Refer to the nameplate to determine the power requirements before connecting electrical power to the unit. All of
the power cords shall comply with safety requirements outlined in the EC Standards (EN60335-1 1 Clause 24.1)
in countries where CE compliance is required. All cords must be HD 21 or HD 22.
Power Cord
Syrup, Water and CO
2
Input Lines