6
620906904
START-UP AND OPERATING INSTRUCTIONS
Fill the hopper with ice and replace the lid. Allow 10 to 15 minutes for the cold plate to cool down. Repeat this
procedure whenever the dispenser has been standing overnight or other long periods without ice use. Start up
the beverage system and adjust faucets to the proper brix. Contact your local syrup distributor for complete
information on the beverage system.
To dispense ice, hold cup under ice chute and press the appropriate size button on the ice portion control lo-
cated above the ice chute. An extra ice portion may be obtained by pressing the increase key (
Y
) before press-
ing the button.
For beverage dispensing, place a cup on the cup rest against the faucet lever of the desired flavor. Beverage
will be dispensed automatically filling the cup and shutting off. A delay feature is provided in the faucet controller
to “top-off”the drink after shut off.
CAUTION: Use caution to avoid spilling ice when filling dispenser. Clean up immediately
any spilled ice from filling or operating the unit. To prevent contamination of ice, the lid
must be installed at the unit at all times.
ICE PORTIONING SYSTEM OPERATION
INDICATOR LIGHT
DECREASE
SMALL
LARGE
MEDIUM
X-LARGE
INCREASE
FIGURE 7. CUP SIZE LABEL
The ice portioning system consists of three main components:
1. Ice Portion Control
2. Ice Gate Mechanism
3. Solenoid Operated Air Valve
When a size button on the ice portion control is pressed, the control supplies a voltage to the air valve for a brief
period of time. The air cylinder attached to the ice gate will then open the ice gate for a short time allowing ice to
be dispensed from the ice chute.
The ice portion control has five modes to allow adjustment of the ice portions and for normal operation. They
are as follows: (Refer to Figure 7)
MODE
INDICATOR STATUS
Normal operation
Green
Cleaning mode
Red/Amber flashing
Normal ice portion adjustment
Amber
Extra ice portion adjustment
Red
Agitation refill time adjustment
Amber flashing
The control will return to Normal Operation Mode (green indicator) automatically if a button has not been oper-
ated for a period of one minute whenever one of the three adjustment modes have been accessed.
