Cornelius FlavorFusion, Руководство по установке

Страница: 12 / 26

Setting Water Flow Rate
Setting the water flow rate will require a timed dispense. To accomplish this, the following procedure should be
followed:
1. Enter programming mode for the valve block by
simultaneously pressing and holding both pro-
gramming buttons for 4 seconds. The LED’s for
flavors 1-4 should flash off and then back on.
The drink icon should turn off.
2. Set the valve block to a 4 second pour mode by
simultaneously pressing and holding Flavor 1
and Flavor 4 buttons until the flash pattern for all
four buttons changes.
3. Place an empty ratio cup under the appropriate
nozzle and press the left program button for a 4
second dispense of carbonated water. There
should be approximately 10 oz. dispensed.
4. If necessary, adjust the water flow control,
empty ratio cup, and repeat step 3. Otherwise
empty ratio cup and repeat step 3 using the right
program button for plain water.
5. Exit 4 second pour mode by simultaneously pressing and holding Flavor 1 and Flavor 4 buttons until the
flash pattern for all for buttons changes.
6. Exit programming mode by simultaneously pressing and holding both programming buttons for 4 seconds.
FlavorFusion Installation Manual
Publication Number: 620055764INS - 8 - © 2012, IMI Cornelius Inc.
Figure 4.
Figure 3. Valve with Flow Adjusters
(see plumbing diagram for plumbing and valve configuration)