Corghi HD 1300, Руководство оператора

Страница: 93 / 304

HD 1300 / HD 1300 A Operator Manual 93
EN
D
A
C
B
E
21
If the rim is larger than 36’’ in the clamping point,
insert the specific clamps (A fig.21).
For wheels with a diameter smaller than 20’’, it
is recommended to remove the tool holder (C
fig.21) and position it in the second hole using
the specific latch (E fig.21).
Arrange the wheel in a vertical position on the
level surface of the machine.
Use the turntable spindle carriage translation
controls to set the turntable so that the ends of
the clamps just touch the rim edge.
Then lock the turntable, selecting as the locking
point the area that is as inward as possible
depending on the form of the rim.
When working with wheels with a diameter greater than 1,500 mm, or with a weight
higher than 200 kg, during the phase of loading-locking the wheel on the turntable, it is
mandatory that you work in safe conditions, following the instructions provided below:
- Tip the tool-holder arm backward.
- Install the wheel anti-tipping guard (A, Fig. 22) in its housing.
- Load the wheel in a vertical position (Fig. 22) so that its external side is next to the guard.
- Activate the turntable in the best way for loading and locking the wheel.
- Remove the guard and then proceed with the mounting and demounting operations.
A
22
DANGER