Coretec VCX-7401, Инструкция по установке и эксплуатации

Страница: 10 / 38

Using the PCA-2400 programming cable, connect to the control port. This cable
should be attached to the serial port of an attached PC and the Hyper Terminal
program launched. The PC should have its Com Port configured as:
Baud rate 115,200 kbps
Data bits 8 bits
Parity No Parity
Stop Bits 1 Stop Bit
Flow control None
Activate the HyperTerminal function, normally found in a sub-menu under
ACCESSORIES. Employ the command set as described in the following section.
Password: admin (default)
To change the default password perform the following:
Type:
PASSWORD
<followed by your password (up to 11 characters)>
Where <your password> equals the new password
3. Web Interface
To get to the Login Page of the web interface applet, the user needs to type in the
IP adress of the device into a URL. On the Login Page, shown below, the user will
need to type in the password to login successfully.
10