Coretec VCX-7401, Инструкция по установке и эксплуатации

Страница: 27 / 38

Encoder com ports - 192.168.0.253
Decoder com ports- 192.168.0.254
Example Command: COMIP 192.168.0.10 (points the com port data to an
encoder, decoder, or other device whose IP address is 192.168.0.10)
COM PORT (Com Port)
The com port selection is configurable. However, the default setting should be adequate
for normal operation.
Default:
Com port - 5002
Example Command:
COMPORT 5010
(sets com port to port 5010)
COM RS422 <0|1>
The com port data-format is configurable. The parameter is “0” or “1”, where
“1” enables RS-422 and “0” enables RS-232 format.
Default: 0 (RS-232)
Example Command:
COMRS422 0
(sets com port for RS-232)
COM TCP <0|1>
The Com port can use either TCP or UDP to transfer serial data. TCP
provides more reliable transfer, but requires that the device be configured for
server or client. See the
COM SERVER command for this setting.
1= Use TCP, 0=Use UDP
COM SERVER <0|1>
When using TCP to transfer Com serial data the device needs to be configured
for client or server. The recommended convention is to set the Encoder, which is
connected to the camera PTZ to the server.
1 = server, 0 = client
OSD COMMANDS (On Screen Display)
These permit the configuration of the On-Screen-Display(OSD) properties of the
encoder. This section is for labeling the video stream. The OSD is only supported in D1
resolution streams at this time. The same OSD will be on both MPEG-4 and H.264
encoders at D1 resolution.
OSDENABLE <0|1>
27