Coretec VCX-2400-D, Инструкция по установке и эксплуатации

Страница: 9 / 47

From the command prompt, the operator may view the current configuration by entering the
“
display
” command. This will dump the entire configuration status for the selected encoder. Remember
there are two encoders in one unit. Enter the following configuration for each of the encoder channels.
Take note the IP address must be of valid encoders on the network. The IP addresses below are just used
as an example. Locate a VCX-2400-E (MPEG2 encoder).
Connection Configuration
ip 192.168.5.150 (use a valid IP on your network)
ipmask 255.255.240.0
name CoreTec Encoder
com1 1
com1ip 192.168.5.151 (IP address of the decoder that is sending sub-channel commands)
com1tcp 1 (assume a universal decoder)
com1server 0
com1timeout 10
com1baud 38400
MPEG2 Configuration
The MPEG2 encoder requires the following parameters be configured to your network:
videoip 239.5.5.151 (use a valid IP on your network)
port 4570
bitrate 1000
res cif
fps 15
Saving Configuration
When all the configuration parameters have been entered, they must be saved to memory and the unit
restarted by entering the following command:
Commit
<enter> (please wait a moment until the following prompt appears:)
COMMIT
DONE
Reboot
<enter>