Coretec VCX-2400-D, Инструкция по установке и эксплуатации

Страница: 29 / 47

The following example indicates that all packets sent to hosts on the 62.41.10.xxx subnet should be
routed though the gateway at 192.168.100.2
Example command: GATEWAY 192.168.100.2 62.41.100.0 255.255.255.0
CLEARGATEWAY
Clears the gateway table. There are no parameters. This command clears all entries.
CMDPORT (TCP Command Port)
The TCP command port selection is configurable. However the default setting should be
adequate for normal operation. The command port is used by software that can operate the VCX-2400
devices programmatically. For example, a Microsoft Windows GUI based application.
Default: 5000
Example Command: CMDPORT 5010 (sets TCP command port to 5010)
VIDEOIP (Video Destination IP)
The video destination IP is an address that allows the reception of the MPEG-2 stream by a single
(unicast) or multiple (multicase) device(s).
NOTE: Class D IP addresses, in the range 224.0.0.0 to 239.255.255.255 are called multicast addresses.
The range 224.0.0.0 to 224.0.0.255 is reserved for local purposes and the range 239.0.0.0 to
239.255.255.255 is reserved for administrative scooping. Both the encoder and decoder should be set to
the same Video IP for correct operation together.
Default: 239.5.6.8
Example Command: VIDEOIP 234.5.6.10 (sets multicast IP to 234.5.6.10)
VIDEOPORT (Video Multicast Port)
The video multicast port selection is configurable. However the default setting should be
adequate for normal operation.
Default: 4568
Example Command: VIDEOPORT 4569 (sets multicast port to 4569)