Coretec VCX-2400-D, Инструкция по установке и эксплуатации

Страница: 31 / 47

COM1PARITY, COM2PARITY (Comm Port Parity)
The parity for the comm port can be set to Odd, Even, or None. The parameters for the
COM[1|2]PARITY command are N,O,E, which correspond respectively to None, Odd, Even.
Default: None
Example Command: COM2PARITY N (sets comm port 2 to no parity)
COM1IP, COM2IP (Comm Port IP)
The IP address of the destination for the comm port data is set by this command. A typical setup
would have an encoder and a decoder. The decoder would have a comm port IP address that is the same
as the encoder. And, likewise, the encoder’s comm port IP would be the same as the decoder. Notice that
the default comm ports IP’s are the opposite of the default device IP’s.
Default:
Encoder comm ports - 192.168.0.253
Decoder comm ports- 192.168.0.254
Example Command: COM2IP 192.168.0.10 (points the comm port data to an
encoder, decoder, or other device whose IP address is 192.168.0.10)
COM1PORT, COM2PORT (Comm Port Port)
The comm port port selection is configurable. However the default setting should be adequate for
normal operation.
Default:
Comm port 1 - 5002
Comm port 2 – 5004
Example Command: COM1PORT 5010 (sets comm port 1 to port 5010)