Coretec VCX-2400-D, Инструкция по установке и эксплуатации

Страница: 30 / 47

Comm Port Setup
The VCX-2400 supports two sub-channels that allow the two way transmission of serial data to
selected target devices. The sub-channel can be configured for either RS232 or RS422 operation. It is
not necessary for both ends to use the same configuration. The following is a list of the configuration
items for the sub-channel:
Channel Enable
Baud rate
Parity
IP address of target
TCP port for operation
RS422 or RS232
Certain VCX-2400 devices can be delivered with either one or two comm ports. The ports are designated
as 1 and 2. The commands for configuring the settings use the A or B designation to indicate the port
being configured.
Example(s): COM1xxx for comm port 1 (selects comm port 1)
COM2xxx for comm port 2 (selects comm port 2)
Note: Communications port 2 is also the control port for programming. If this port is also needed for
non-programming related data purposes, the user should program the necessary parameters with the
jumper in place if using the Hyper Terminal method. Upon completion of programming, removal of the
jumper will result in port 2 operating as programmed. If not using Hyper Terminal to program, jumper
should be removed if comm port 2 is to be used.
COM1, COM2 (Comm Port Enable)
This command sets the active state of the comm port. The parameter is “0” or “1”, where “1”
enables and “0” disables the comm port function. At this time the comm port is always enabled and this
command has no effect.
Default: 0 (OFF)
Example Commands: COM1 1 (enables comm port 1)
COM1BAUD, COM2BAUD (Comm Port Baud Rate)
This command sets the baud rate for the comm port. Valid values are 2400, 4800, 9600, 19200,
and 38400. Other data rates may be functional but are not tested.
Default: 9600
Example Command: COM1BAUD 4800
(sets baud rate for comm port 1 at 4800 bps)