Coretec VCX-2400-D, Инструкция по установке и эксплуатации

Страница: 32 / 47

COM1RS422, COM2RS422 (RS-232, RS-422 Data Format)
The comm port data format is configurable. The parameter is “0” or “1”, where “1” enables RS-422
and “0” enables RS-232 format.
Default: 0 (RS-232)
Example Command: COM1RS422 0 (sets comm port 1 for RS-232)
Comm port Command – Further Examples
The following examples set up comm port 1:
COM1 1 – Enable comm port 1
COM1BAUD 9600 – Set comm port 1 baud rate to 9600
COM1RS422 1 – Set comm port 1 mode to RS422
COM1PORT 5002 – Set comm port 1 port to 5002
COM1PARITY E – Set comm port 1 parity to even
COM1IP 192.168.0.10 – Set destination address for data to 192.168.0.10
Encoder Commands
PROFILE
Used to select a desired resolution for the encoded video. It also sets the optimal defaults for
other parameters, such as bit rate. The allowable settings are SIF ½, 2/3, D1. The half and two thirds
settings are relative to the full D1 resolution.
Default: SIF
Example Command: PROFILE ½ (sets resolution to ½ D1)
Note: Since the Profile command selects defaults for other settings, it should be issued before any
other commands relating to the encoded MPEG stream.
BRIGHT
Adjusts image brightness. The acceptable range is from 0 to 255, where a higher number
provides more brightness.
Default: 128
Example Command: BRIGHT 170 (increases brightness from default setting)