Declaration!
Notice!
Danger!
Warning!
Cautious!
Note!
This user manual is a integrated user manual of the E00/E01 series piezoelectric controller. Customers can use
the different modules to assemble and use. Please read this user manual carefully before using this controller.
Follow the instructions in the manual during use. If there is any problem, please contact us for technical
support. If you do not follow this manual or disassemble and modify the product yourself, the company will not
be liable for any consequences arising therefrom.
Please read the following to avoid personal injury and to prevent damage to this product or any other product
connected to it. In order to avoid possible hazards, this product can only be used within the specified range.
Use only the dedicated power cord supplied with this product. Check the power cord before use and confirm
that it is in good condition.
This product should be connected to the ground through the power cord. Use a power outlet with a safe and
reliable grounding wire.
Do not touch any exposed ends of the product and its accessories.
There is high voltage inside, and the chassis must not be opened privately.
Do not pull or plug in the input and output lines and serial ports, I/O, and USB cables while the power is on.
The control method used should be correspond to the selected control method.
Please keep the surface of the product clean and dry, and do not operate in a humid or Large electrostatic
environment.
After use, the output voltage should be cleared to zero and the closed loop state is switched to the open loop
state before the controller switch is turned off .
The piezoelectric power amplifier described in this manual is a high-voltage device capable of outputting high
currents, which can cause serious or even fatal damage if not used properly.
It is strongly recommended that you do not touch any parts that connect to the high voltage output.
Special Note: If you connect it with other products in addition to our company, please follow the general
accident prevention procedures.
Operating the high-voltage amplification requires training professional operators.
If the voltage exceeds the PZT's tolerable range, it will cause permanent damage to the PZT. Before adding
voltage to the PZT poles, it must be ensured that the positive and negative poles of the PZT are connected
correctly and the operating voltage is within the allowable range of this PZT.
The E00/E01 housing should be installed on a horizontal surface in an area with a 3CM air flow area to prevent
internal convection in the vertical direction.
Insufficient airflow can cause equipment to overheat or premature instrument damage.
When there is no corresponding module in the E00/E01 system, please do not control the module for the
system. When there is no module, there is no control signal to provide a loop for the power amplifier module,
which will cause the system to malfunction.
The module position corresponding to the E00/E01 system can only be placed in the corresponding module. If
you wanna upgrade your E00/E01 system, please contact the sales engineer or contact our customer service
department, and the contact information in chapter 9.
DECLARATION
