E00/E01 Series Modular Piezo Controller User Manual
12
● Modules installed in the chassis
● Power cord
● Analog control line
●PZT output line (depending on the presence or absence of piezo actuators, nanopositioning
stage, micro-motion stage)
● E00/E01 Series Piezo Controller User Manual (this document)
3.1.2 If one or more E09 modules are installed, the following items are included:
● Sensor monitoring cable for E09.Sx/Lx models
3.1.3 If one or more E17/E18 modules are installed, the following items are included:
● E17/E18 Software Operation User Manual
● E17/E18 software installation CD
● Serial cable
● USB cable
● I/O slot MDR connector cable
3.2 System operation and safety measures
NOTE! Improper installation of the E00/E01 system can result in personal injury or damage to the
E00/E01 system!
● Installation and use of E00/E01 system should be close to the power supply, so that the power
plug can be disconnected from the main power supply quickly and easily.
● Connect the E00/E01 system using the supplied power cord.
● If the power cord supplied by the company must be replaced, use a power cord of sufficient size
and be effectively grounded.
NOTE! The E00/E01 system is installed or placed incorrectly, which may cause high temperature
or overheating during system operation!
● The E00/E01 system should be installed in an area with an air flow area of at least 3 cm from
the horizontal plane.
● Prevent vertical convection in the vertical direction. Insufficient airflow will cause overheating or
premature instrument damage.
● Ensure a fully ventilated installation environment.
NOTE!
When the piezo driver is connected to the E00/E01 system, it may cause oscillation and
cause irreparable damage!
