User and Maintenance Manual
Failsafe hydraulic brake ID 2000N
Model ID 2000N-116
Date: 2014/06/27
Revision: 1.1
www.coremo.it
Page
20
of
25
14.
Put back the cup springs (Photo 34).
Photo 34
15.
Put back the cover (D71242) on the brake body (E80834) using the screws (C61421) and
washers (C61321) (Photo 35). Tighten the M10 class 12.9 (C61452) screws in a diagonal
sequence with a tightening torque of 79 Nm (Photo 36).
Photo 35
Photo 36
16.
Put back the lining pads following the reverse sequence of the procedure described in
points 3 and 2 of section 9.2.
17.
Connect the power line, power up the brake and insert the safety hook (C62257) in its seat
on the thruster which protrudes from the cover.
18.
Cut off the control pressure and disconnect the power feed line.
19.
Reinstall the brake on the machine.
20.
Reconnect the power feed line and power up the brake.
21.
Remove the safety hook (C62257) and bleed air from the circuit as described in point 5 of
section 7.