User and Maintenance Manual
Failsafe hydraulic brake ID 2000N
Model ID 2000N-116
Date: 2014/06/27
Revision: 1.1
www.coremo.it
Page
18
of
25
6.
Cut off the control pressure and disconnect the power line.
7.
Remove the lining pads as described in points 2 and 3 of section 9.2.
8.
Unscrew the anchoring screws (C61421) (Photo 22), remove the cover (D71242) (Photo 23)
and the cup springs (C62410) (Photo 24).
Take special care during these operations as the brake contains preloaded springs,
proceed therefore gradually with the utmost care and attention so that they are
completely released and do not jeopardize any aspects of safety.
Photo 22
Photo 23
Photo 24
9.
Remove also one shim C62256 for the ID 2000N-58 brake and two shims one shim
C62295 for the ID 2000N-116 brake (Photo 25).
10.
Remove the play adjuster (D71244) from the thruster (Photo 26).
Photo 25
Photo 26
11.
Carefully remove the thruster (D71243) from the brake body (E80834) carefully allowing
compressed air to enter from the feed hole (Photo 27) until the thruster has come out
completely (Photo 28).
