©CORE Lighting Limited 2012
11
4.5.7.
SET WDMX
*This is a factory setting mode to adjust the internal operation of the Wireless DMX module and
should not be used unless under technical supervision from CORE Lighting or a technically
competent distributor.*
4.6.
WIFI Status
WiFi (where fitted as an upgrade) may be activated by selecting “WiFi ON” in the menu and pressing
the “enter” key. When the counter reaches “3” the unit is ready to receive WiFi requests. (Units that
are not fitted with WiFi will remain at WiFi 0).
While WiFi is on the display will remain in this state and cannot be adjusted from this point using the
keypad except for switching WiFi off. Switching off is a matter of entering “WiFi OFF” then “enter”.
Note the importance of hitting the “enter” key.
4.7.
ADDR DMX Address
This is the address channel for Wireless DMX.
Channels 1 to 506 may be selected, although from the selected channel the subsequent 5 channels
are then allocated as below.
Each 5 steps represents the following order of channels:
RED
GREEN
BLUE
WHITE
BRIGHTNESS
Values of 0 to 255 may be input to each of those channels.
NOTE – A VALUE MUST BE USED FOR BRIGHTNESS, OTHERWISE NO LED OUTPUT WILL BE
OBTAINED FROM ANY OF THE COLOURS (Brightness x Colour Value = light output).
5.
WIRELESS INTERFACES
The Point30 Unit uses Wireless Solutions W-DMX protocol for receiving and sending brightness and
colour data. There are 512 channels of which the unit uses five. WiFi Control is also available to
replace local control from the keypad with remote control from devices with a WiFi interface and
browser software built-in.
5.1.
W-DMX Receive
A W-DMX Receiver is built into every unit thus enabling it to operate in SLAVE mode. See Section
4.2.3 for operational details.
