12
If the appliance is in
Stand-By-Mode,
it is put in
Operating-Mode
by pressing
successful operation acoustically.
On all heaters a ´0` appears and all
Decimal Point
of the heater flashes (1
sec on, 1 sec off).
If there is no operation within 10 sec, the display of all heaters will turn off.
If the displays are turned off, the heater will be set into
Stand-By-Mode
.
If is pressed more than 2 sec (in
Operating-Mode
), the appliance is
switched off and is set into the
S-Mode
again. The appliance can be turned
off by pressing at any time; even if other buttons are pressed
simultaneously.
If there is a residual heat of a heater remaining, this will be indicated in the
correspondent heat setting
Heater Display
.
Select Heater
If a single heater is chosen with the corresponding
Active/Deactive Heater
Button
, the
Decimal Point
of the related
Heater Display
flashes. For the
Heat Setting Buttons
or .
The buttons must be pressed within 3 sec, otherwise the heater selection
is erased and heat setting dot will disappear (
Decimal Point
). If there is no
further operation within 10 sec, the heater falls back into the
S-Mode
.
The heat setting can always be changed by pressing or between
level 1-9.
Each button operation or each display change is quitted by a buzzer signal.
