Cooper Industries Inc.
Crouse-Hinds Division IF 1551
PO Box 4999, Rev 1
Syracuse, New York 13221 • U.S.A. New 01/08
Copyright© 2007, Cooper Industries, Inc.
Photocell Wiring
The recommended minimum wire gauge is
#16 AWG. Run the wires in conduit.
Connect the wires from the photocell to
TB2 in the controller as shown in Figure
2-5.
Internal Wiring for Photocell
J505-1 and J505-2 are used internally for
the photocell. Be certain that these
connections are correct before applying
power, otherwise equipment damage will
result. See Figure 2-6.
Installation Checklist
Controller Checklist
Consult the installation drawings for
placement, mounting, wiring details, and
power phasing.
•
Provide a power disconnect switch or a
circuit breaker.
•
Leave slack in the wires.
•
Ensure that the primary power wires
are of adequate gauge.
•
Ground the case to the site grounding
system.
Photocell Checklist
•
The photocell should face the polar
sky
•
It must not view artificial lighting
•
Consult the installation wiring diagram
for the system
