□
Please note: the ceiling ducted type A/C shown in the figure above
is taken as an example. Other types may vary from this one.
Signal receiver
Virtual line between signal
transmitter and receiver
Max. transmission
distance: 5m
Controller
●
Signal receiver will beep when signal received. When
there is no beeping, the signal is not successfully
transmitted, please try again.
●
Beep may not be heard due to interference of noises nearby.
Note: In some special cases, such as in centralized control
state, the signal is received but indoor unit does not operate,
at this point the buzzer gives a long beep for 1 second.
ON/OFF
For protection of the compressor, it should be powered on
12 hours before startup. Do not switch off the power source
when A/C is regularly used.
After the controller is powered on, the receiver LED will
keep flashing at every 0.5 second, which is a process of
initialization and no operation available, and then goes off.
□
●
Do not place the controller at any location
with elevated temperature in case of
malfunction.
·
Direct sunlight
·
Nearby the stove
●
Please be careful when using the controller,
otherwise it may break down if dropping
onto the ground or affected by damp.
When operating the controller, according to
[5. Signal transmission], the signal transmitter of controller
should point to the receiver on indoor unit, and operate by
pressing function buttons.
Tips
. Operation
Caution
3
