1
1
2
Press "ON/OFF" to start operation, then
press "Louver" to adjust direction of air
flow. The louver will adjust as the following
sequence at each press.
Louver setting when connected with 3D panel.
Hold "Health" for over 3s to switch to "3d" for
controlling 3D panel.
3
When the controller is ON,
press "Louver", and the
icon of up&down air supply
flashes. During flashing,
press to adjust
the location of louver.
The icon stops flashing
after 5s, and the louver is
at the set location.
When the controller is ON,
press "3D/U.L." and the icon
is displayed, indicating
the louver is in 3D air supply
mode.
6
When the controller is ON,
press "Louver", and the icon
of up&down air supply
flashes, then press "Louver"
again, the icon of left&right
air supply flashes. During
flashing, press to
adjust the location of louver.
The icon stops flashing after
5s, and the louver is at the
set location.
6
