Cooper & Hunter Arctic NG Wi-Fi Series, Руководство пользователя

Страница: 13 / 111

Hex nut diameter
15~20
30~40
45~55
70~75
Tightening torque (N m)
4
All wires of indoor unit and outdoor unit should be
If the length of power connection wire is insufficient,
Add insulating pipe in the indoor drain hose in order
For the air conditioner with plug, the plug should be
panel
1
drain hose
2
2
outlet pipe
tape
NOTE
NOTICE
Step 7:
Connect wire of indoor unit
For the air conditioner without plug, an air switch
screw
wiring cover
hole
power connection
wire
Step 6:
Install drain hose
1
12
Bind the joint with tape
indoor unit
Wrap the indoor pipe and joint of connection
pipe with insulating pipe, and then wrap it
with tape
insulating pipe
insulating pipe
drain hose
Open the panel, remove the screw on the wiring
cover and then take down the cover
Connect the drain hose to the outlet pipe of
outlet
pipe
drain hose
Make the power connection wire go through the
cable cross hole at the back of indoor unit and
then pull it out from the front side
●
●
3.
1.
●
The power cord and control wire can't be crossed or
winding.
The drain hose should be bound at the bottom.
5.
upper hook
indoor unit
band
●
NOTICE
lower hook of
wall-mounting frame
2.
3.
indoor
4.
wall pipe
Step 9:
Hang the indoor unit
4.
2.
NOTICE
outdoor
3.
sealing gum
4.
gas
5.
Step 8:
Bind up pipe
1.
pipe
liquid pipe
drain hose
indoor and
outdoor power cord
NOTI C EE
The wiring board is for reference only, please refer
to the actual one.
13
Do not bend the drain hose too excessively in order
to prevent blocking.
drain hose with the band.
connection pipe
drain hose
band
indoor power cord
Bind up the connection pipe, power cord and
Put the bound pipes in the wall pipe and then
make them pass through the wall hole.
Hang the indoor unit on the wall-mounting
frame.
Stuff the gap between pipes and wall hole
with sealing gum.
Fix the wall pipe.
Check if the indoor unit is installed firmly and
closed to the wall.
Remove the wire clip; connect the power conn-
ection wire to the wiring terminal according to
the color; tighten the screw and then fix the po-
wer connection wire with wire clip.
Bind them evenly.
The liquid pipe and gas pipe should be bo-
und separately at the end.
Put wiring cover back and then tighten the screw.
Close the panel.
Reserve a certain length of drain hose and
power cord for installation when binding th-
em. When binding to a certain degree, sep-
arate the indoor power and then separate
the drain hose.
N(1) 22 3
black
Outdoor unit connection
yellow-
green
blue brown