Coonara Royal Classic, Руководство по установке

Страница: 6 / 31

Revised: 02/12/2015 2/12/2015
6
Instructions for operation with THERMOSTAT
The Coonara Classic Gas log space Heater has been designed for a simple and efficient operation
to provide you with a higher heat output than most other heaters in the market. The optional heat
transfer kit means that your heater will provide you with a fully controlled modulated supply of
heat, from a pleasant and steady warmth to the strongest heat output, to reach almost any corner
of your home.
PRE OPERATIONS CHECKS
Prior to operating the heater, ensure that the flue terminal is not obstructed. Furthermore, make
sure there are no combustible objects leaning against, resting on, or within the immediate vicinity
of the unit. Check that the heater main power and gas supply are connected and switched on.
OPERATING THE HEATER
The heaters are operated by the room thermostat
1 -
To ignite your heater press Powe r Button on the thermostat and the heater will automatically
start the ignition sequence. Please refer to the Thermostat Operating Manual supplied for
further instructions. After approximately 30 seconds of self-checking the heater will ignite.
2 -
The heater will always start in the low heat setting and (unless already warm) the heater will
warm up for at least 2 minutes before automatically going to the higher flame setting.
3 -
The fan will not start until the heater has reached the minimum operating temperature.
4 - During first time firing of this appliance, an odour may be noticed for a short period of time
while the paint cures. It is advisable to leave the windows open during the first few hours of
the very first operation only.
TURNING THE APPLIANCE OFF
Press power button on thermostat once. The room fan will continue to operate on & off until all
residual heat is exhausted into the room.
Please note:
1 - This appliance cannot be operated without the fan running.
2 - Due to the performance and efficiency of the heater, steam may be noticed coming from the
flue terminal on cool days.
3 - As this appliance has a luminous effect some slight carbon deposition may occur.
OPERATING THE ROYAL INBUILT AND FREESTANDING HEATER
During first time firing of this appliance, an odour may be noticed for a short period of time
while the paint cures. It is advisable to leave the windows open during the first few hours of the
very first operation only.
When the heater is turned on there is an initial delay time (purge time) of 30 seconds. Once this
time has elapsed, your heater will light via the electronic ignition system. Regardless of the heat
setting, the heater will start on high for approximately 10 seconds before switching back to the
last heat setting used. There will be a further 1 minute delay before the room air fan turns on.