Coonara grange, Инструкция по эксплуатации и установке для потребителя

Страница: 9 / 33

Revised: 01/09/2016 13/02/17
9
INSTALLATION OPTIONS:
* ONLY TO BE CARRIED OUT BY AN AUTHORISED PERSON!
The Grange inbuilt Heater is a zero clearance appliance and can be optionally installed in a
false fireplace or wall cavity made of combustible materials such as wood or chipboard.
Coonara provide the heater with their own flue kit, of flexible pipes of 60mm and 50mm
diameter for the inlet and exhaust. For the gas supply a flexible hose is provided and must be
used.
Notice: F or Horizontal flue installations more than 1 meter long, the
Air intake restrictor plate, located in the gas cowl inlet connection, must be removed by
using a Tin-Snip or similar tool. See page 13.
SERVICE INSTRUCTIONS - INBUILT/FREESTANDER
To access flue fan, over temp switch and the thermistor, the heater needs to be removed. To
access all other components the following steps apply:
To remove tray for service:
1. Undo gas connection going into gas valve and flow tube at firebox.
2. Pull out igniter cable x 2 and heat sensor cable x 1. These are clipped into blue box
and RH side.
3. Unclip plastic wire connections (plugs) x 3.
4. Pull silicone tubes off pressure switch x 2.
5. Undo two wing nuts. Lift fan up and pull forward. The tray will come free for
service.
6.
To access firebox, read installation instructions Page 11 and 12.
To refit tray
7. Undo hex nut holding fan down. The nut is located behind the capacitor. Slide tray
back in and pull forward. Then lock down with two wing nuts. Turn fan on slight
angle so LH corner enters cut out first. Twist fan into position and fix with hex nut.
Then follow dismantling procedure in reverse.
ALL INBUILT MODELS ARE TO BE PLACED ON A FLAT LEVEL
SURFACE TO PREVENT RATTLES
3
3
4
3
4
2
2
2
1
5
1