UMD V3 Installation Manual - Remote Control
13 November 2018
Page
17
of
39
Important Note:
The RFID Tags supplied with a UMD are specific for that particular UMD they must be kept
with and installed with the specific UMD. If RF Tags from another UMD Kit are installed they will not be able to
report to that UMD.
Temperature and Door Tags need to be located in a position within the trailer where they will not be damaged
in the trailers normal daily operations
–
by fork-lifts when loading pallets etc.
Picture 14: Wireless Temperature Tags Locations
Temperature Tag located above the load
line along the trailer wall.
Temperature Tag located next to the Return Air duct
Cooltrax Wireless Door Tag:
The location of the Door Tags and Magnet will vary according to the various body types of the trailer and
whether the fitted doors are roller or barn style. The important consideration, again, is to locate the Tag and
Magnet in a position where they will not be damaged. This requires a careful assessment by the installer on a
case by case basis as there are so many variations from trailer to trailer and even between the different door
types.
Cooltrax provides brackets for both types of door installation.
Installation Options:
1.
On the Inside of the Barn doors with the magnet located on the RH door (looking from inside the trailer
out
2.
If the Trailer body has a lip along the top at the rear then the tag can be located on the inside of that lip
where it is protected and the magnet attached to a bracket on the inside of the door
3.
In the case of a roller type door the tag is typically located on the inside LH side wall directly adjacent
to the roller door and the magnet and spacer is located on the roller door itself
–
checking for
clearance when the door is “rolled up”. See picture below
