Cool Energy inverTech CE-iVT18, Инструкция по установке и эксплуатации

Страница: 4 / 37

Page | 4
Cool Energy inverTech Manual v6.6 2020 ©
Transport of Heat Pump
When transporting your heat pump its important to keep it upright.
The refrigeration system inside contains oil, gas and liquids which can be disturbed when
moving your heat pump. If at any stage during transporting your unit it is inclined more
than a 45° angle, its important to leave the unit upright for at least 4 hours to allow the
refrigeration system to stabilise again before use.
IMPORTANT SAFETY INFORMATION FOR THE END-USER
•
Installation of the appliance must only be carried out by persons with suitable competence.
•
Do not attempt to modify, repair or service the appliance yourself.
•
Do not insert body parts or any other items into the air inlet or outlet.
•
Do not start or stop the unit by removing the power cable; always use the controls and switches
provided.
•
If installed outside, ensure the appliance is protected from prolonged exposure to large quantities
of water.
•
Do not operate the unit or the programmer with wet fingers.
•
Keep the programmer unit of out of reach of children.
•
The electrical supply must be isolated during a heightened risk of lightning strikes.
•
Do not attempt to move the appliance once it is installed; this must be carried out by a qualified
engineer.
•
Isolate the electrical supply to the appliance if an odour presents, or scorching is detected.
•
Only use this appliance for the purpose intended.
•
Ensure the area around the appliance is clean, well-ventilated and kept free of all obstructions.
•
Do not keep items on top of the appliance or use it to support other appliances.
•
Do not under any circumstances stand on the appliance.
•
Isolate the electrical supply to the appliance if it is to be switched off for a period of more than two
months.
•
Periodically check the condition of any supports for deterioration.
•
Do not wash the unit with water, alcohol, benzene, thinner, glass cleaner or powders.
•
During cleaning, isolate the electrical supply to the appliance.