Moving and setting up the appliance
CONVOVent mini / mini 2in1
35
►
Unpacking
Unpacking the appliance
Follow the steps below to unpack the appliance:
Step
Action
1
Remove the outer packaging.
2
Unpack the appliance. Do not use any sharp objects during the process.
Please ensure that you dispose of packaging in an environmentally friendly way.
3
Pull off the protective film.
4
If you suspect the appliance has been damaged during transit, notify your dealer/carrier immediately.
Please notify the manufacturer in writing within three days (with photo if applicable).
Danger:
Never install or put into service a damaged appliance or an appliance with damaged power leads
under any circumstances.
►
Installing the CONVOVent mini
Hood falling down
Risk of crushing from hood falling down
If the hood is not installed correctly on the combi steamer, it may slip and fall down.
Secure the hood.
In order to secure the hood, use the mounting parts intended for this purpose.
Preparing the appliances
Follow the steps below to prepare the appliances:
Step
Action
Illustration /
1
Make sure that the combi steamer is in a completely
horizontal position.
Warning:
Risk of toppling over. Observe all applicable national
regulations and standards.
See instructions in the combi steamer
installation manual.
2
Disconnect the combi steamer from the power supply.
3
Remove the protective film from inside and outside the
hood.
4
Clean the top and top rear section of the combi steam-
er thoroughly. Use alcohol or ethanol, for example.
