Service and Repairs
CONVOVent mini / mini 2in1
53
Removing the cover assembly
To remove the cover assembly, follow the steps below:
Step
Action
Illustration /
1
Disconnect the hood and the combi steamer from the power
supply.
2
Remove all screws and nuts from the cover assembly.
Please note:
2 screws are located on the rear of the appliance.
2 nuts are located on the front of the appliance.
These 2 nuts can be accessed by removing the front panel.
Removing and fitting the front
panel
on page 32
3
Lift off the cover assembly from the top.
Warning:
Use at least two people to lift the cover assembly.
When lifting the hood off the combi steamer, watch out for the
intake pipe on the top of the combi steamer.
4
Carry out the other work that needs to be done.
Replacing the fan
Replacing the supply module
Replacing the ON/OFF switch
5
Refit the cover assembly in the reverse order.
6
Plug in the mains cable to the hood, turn the ON/OFF switch on
and test the system.
First-time use
on page 46
7
Start up the combi steamer.
Replacing the supply module (C006)
To replace the supply module, follow the steps below:
Step
Action
Illustration /
1
Disconnect the hood and the combi steamer from the power
supply.
2
Remove the hood cover assembly.
Removing the cover assembly
3
Remove the screws from the cover of the electrical connection
box.
Please note:
4 screws (1 screw on each side) are located along the wide side
of the electrical connection-box cover.
4
Remove the 2 fixing screws holding the supply module onto the
housing of the electrical connection box.
5
Replace the faulty supply module with a new one, and follow the
steps in the reverse order to refit the new supply module.
6
Place the cover assembly on the combi steamer and fix it in
place.
