Moving and setting up the appliance
CONVOVent mini / mini 2in1
39
Step
Action
Illustration /
2
Sticking the adhesive 'top fixing element' onto the
combi steamer
2.1
Use the alcohol pads supplied to remove any grease
from the contact surface to improve adhesion.
2.2
Position the cover on the combi steamer so that it is
flush with the sides and back.
2.3
Trace the contours of the corners at the front right and
left corners with a pen.
2.4
Stick the 'top fixing element' on with threaded bolts
facing forwards, positioning it between the marks.
The indicator arrows on the fixing element must point
forwards.
Fitting the condensation hood
Follow these steps to install the hood:
1
Connect the tubes to the air vents using the hose clips.
2
Place the condensation unit on the combi steamer.
2.1
Position the pipe ends for the air vent in the fitted
tubes.
2.2
Place the fixing brackets over the threaded bolts.
2.3
Push the tubes up as far as they will go, then tighten
the hose clips at the lower end of the tubes on the air
vents of the combi steamer.
2.4
Fasten the fixing brackets to the combi steamer with
two nuts.
3
Slide the ventilation pipes over the ventilation ports.
4
Insert the grommets into the holes made in the cover
for the ventilation pipes.
5
Place the cover over the condensation unit onto the
combi steamer.
Make sure that the grommets fit over the ventilation
pipes and that the cover fits over the threaded bolts on
the 'top fixing element' .
6
Fasten the front cover with two nuts.
7
Fasten the rear cover to the fixing brackets with two
screws.
8
Fit the front panel on the front of the cover.
Removing and fitting the front panel
on page
32