following syntax to set or change a single parameter for a single slot
assigned to an HDBaseT or HDMI output port.
ZoneAvPair HDBT_Out {Port} Slot {Slot} {Parameter [= Value]}
Examples: ZoneAvPair HDBT_Out B Slot 5 VideoSrc = HDMI_In 2
ZoneAvPair HDMI_Out J Slot 3 Load
•
Multi-Port Command Format
Use the following syntax to set or change a single parameter for
multiple ports. Note that each additional port uses the “+” character for
separation. The number of ports allowed in a single command is
limited by the number of ports on that specific interface.
<Command> {Port1}+{Port2}+{Etc.} {Parameter [= Value]}
Examples: ZoneLineOut A+B+C Treble = -12
HDBT_Out A+D+H Mute
•
Multi-Slot Command Format (ZoneAvPair)
The ZoneAvPair command allows for multiple slots on a single HDBaseT
or HDMI output to be assigned the same value simultaneously. Use
the following syntax to accomplish this. Note that each additional slot
uses the “+” character for separation. The number of slots allowed in
a single command is limited by the number of slots on that specific
interface.
ZoneAvPair HDBT_Out {Port} Slot {Slot1}+{Slot2}+{Etc.} {Param [=
Value]}
Example: ZoneAvPair HDBT_Out B Slot 1+3+5 VideoSrc = HDMI_In 2
•
Multi-Parameter Command Format
Use the following syntax to set or change multiple parameters for
a single port. Note that each additional parameter uses the “,”
character for separation and spaces are allowed. The number of
parameters allowed in a single command is limited only by the
number of individual parameters that command has.
<Command> {Port} {Param1 [= Value]}, {Param2 [= Value]}, {Etc.}
Examples: ZoneLineOut C Treble = -12, Mute, Delay = 100
HDBT_Out A VideoSrc = HDMI_In 1, AudioSrc = HDMI_In 1
•
Multi-Parameter Command Format (ZoneAvPair)
The “VideoSrc”, “AudioSrc” and “Load” parameters may be
combined on a ZoneAvPair command. Note that the “,” character is
used for separation.
ZoneAvPair HDBT_Out {Port} Slot {Slot} {Param1=Value},
{Param2=Value}
Example:
ZoneAvPair HDBT_Out B Slot 5 VideoSrc=HDMI_In 2, AudioSrc=CoaxIn 1
• Complex Multi-Port/Parameter Command Format
It is possible to have a single command that affects multiple ports with
multiple groupings of parameters. All previously explained syntax rules
must be observed and each additional set of ports/parameters are
separated by the “&” character.
<Command> {Port1}+{Port2}+{Etc.} {Param1 [= Value]}, {Param2 [=
Value]}, {Etc.} & {Port1}+{Port2}+{Etc.} {Param1 [= Value]}, {Param2 [=
Value]}, {Etc.} & Etc.
Example:
Содержание 15425
Страница 1: ...10x10 HDMI 6G HDBaseT Matrix with 48v PoH 15425 Operation Manual ...
Страница 47: ......