> Incoming 720p50 can only be used with 50 or 25 recorded rates (and 1080p25 with 25 only).
> Press right or left arrows during record to dynamically adjust crank rate.
> The recorded bit rate of cranked recording is reduced based on the ratio of the recorded
frame rate to the incoming frame rate. For example, a 720p60 incoming signal @ 280 Mbit,
with record rate of 24 (yielding 720p24 recording) will adjust the bit rate by a ratio of 24/60,
giving a recorded bit rate of 112 Mbits /sec. This is necessary due to the way the nanoFlash's
codec handles cranking.
> 720p24 / 25 / 30 can not be played out of the nanoFlash at this time.
> For best results, set your camera to the full frame rate. For example, for cranking in 720p
PAL set the camera to 720p50 (not 720p25), for cranking in 720p NTSC set the camera to
720p60 (not 720p30 nor 720p24).
> Do not use Crank mode in combination with Pre-Record Buffer (System->PreBuffer), Time-
Lapse, 720p60->30/50->25, or 3:2 Pulldown Removal.
720p60->30, 50->25
(ver1.5.126)
Cuts the frame rate in half for incoming 720p60 or 720p50 signals by throwing out every other
frame. Useful, for example, with cameras with a 720p30 or 720p25 mode which then double
the frame rate of the camera's SDI output. The nanoFlash bit rate in this mode is applied to
the reduced frame rate. For example, @ 280 Mbit from a 720p50 source reduced to 720p25,
the recorded bit rate will be the full 280 Mbit.
> Do not use this mode in combination with Pre-Record Buffer (System->PreBuffer), Time-
Lapse, Crank, or 3:2 Pulldown Removal.
HDMI Rx Color (HDMI input only)
Choose between Full color and Legalized color. Most HDMI based cameras are Full color,
computers and game boxes are examples of Legalized HDMI video sources.
35 Mbit 1080 Width
Choices are: 1920 (for 35 Mbit 1920x1080 4:2:0 XDCAM EX) or 1440 (for 35 Mbit
1440x1080 4:2:0 XDCAM HD). This setting only applies when Video->Bit Rate->CF HD Rate
is set to 35 Mbit. Bit rates of 50 Mbit and above are always 1920x1080 4:2:2 (for 1080
sources). (ver1.5.31)
Record Tally (1.5.249)
Places a red bar on SDI output during record, as a record indicator. Also requires Video->E to
E Direct to be activated.
nanoFlash
16
