CONVECTAIR CALYPSO 7826, Инструкция по установке и эксплуатации

Страница: 8 / 27

8
Securing the Wall Bracket:
1 Remove the wall bracket from the appliance by releasing the
two clips, using a screwdriver (see Fig. 2).
2 Position the wall bracket over the desired
location on the wall and mark the 4 fixing
holes, following the dimensions in Fig. 3.
3 Secure the wall bracket with at least 4
screws (Ø 5.5 max), ensuring it is in the
correct orientation and at the correct
height. Ensure that the correct screws, and
anchors if necessary, are used to allow the
unit to be securely mounted on the wall.
It is recommended that at least two of the
screws are attached to studs in the wall.
NOTE 1: Make sure to follow the clearances
shown in Fig. 1.
NOTE 2:
The unit must be secured on the
wall bracket. The use of adhesive to install the
bracket or the device is prohibited.
Assembly:
- To install the heater, place the unit in front
of the wall bracket; insert the lower legs of
wall bracket into the slots on the bottom and back of the heater. This is made easier
by positioning the device slightly tilted forward.
- Clip the top of the wall bracket, and ensure it is secure.
Entrée de câble
240mm
(9 15/32")
275mm
(10 27/32")
300 mm MINI
(12")
Fig. 3
Ne pas
obstruer
cette zone
A
B
A = 155 mm (6 1/8")
B = 30 mm (1 3/16")
Fig. 2
Do not
obstruct
this area
Wire
entrance