24
The Calypso is equipped with two safety cut-outs which shut off the fan and the heating
element in case of overheating.
To reset the safety cut out:
1. Shut off the power to the heater at the breaker.
2. Check the heater and correct the cause of overheating (blocking, covering or dust).
Clean the grilles and filter screen if they appear dirty.
3. Wait 5 minutes, turn the power back on at the breaker and start the heater to check
that it operates properly.
For best performance and maximum efficiency of the appliance, regular maintenance
is required. To remove dust on the outside of the heater and on the grilles, use a soft
cloth. To remove a stain, dampen the cloth. To remove dust and debris that accumulate
inside the heater, remove the filter screen, vaccum it, and put it back before operating
the unit.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS, AS THEY COULD
DAMAGE THE EPOXY COATING.
ALL SERVICING ON CONVECTAIR APPLIANCES MUST BE CARRIED OUT WITH THE
POWER OFF, AND BY QUALIFIED AND AUTHORIZED PERSONNEL.
Recommendations and Advice
Your
CONVECTAIR
heater becomes hot during use. Particular care must be taken in order to educate
young children.
Do not insert objects into the openings of the grilles; this could cause short circuits, fires or damage to
devices.
Any other use not recommended by
CONVECTAIR
may cause short circuits, fires or injury to users.
In some conditions, the grille of the devices may turn yellow after some time. This phenomenon is not
due to a manufacturing defect. Rather, it is caused by the ambient air which contains fumes or suspended
particles, which are heated and then exhausted through the grille. This phenomenon is particularly visible
on «pure white» devices and can cause severe discolouration.
Prevention: it is advisable to clean the grills frequently, especially for appliances installed in places
exposed to cigarette smoke or in the kitchen. CONVECTAIR devices must never be used during
construction work or other activities which generate a lot of dust.
When switching on the
CONVECTAIR
for the first time, a slight smoke may emerge from it. This
phenomenon is quite normal and will go away on its own after 2 or 3 minutes of operation of the device.
Overheat Protection
Maintenance
Содержание CALYPSO 7826
Страница 2: ...2...
