Convaid YoYo, Руководство пользователя

Страница: 23 / 44

23
SETTING UP
Seat depth adjustment
1. Remove occupant from the chair
2. Remove seat cushion upholstery
3. Loosen the two (2) adjustment knobs on the
underside of the seat pan. FIG. 41
4. Loosen any accessories that may prevent the seat
pan from sliding.
5. Push or pull on the front of the seat, evenly on both
sides, until the seat reaches the desired depth.
FIG.42
6. Tighten the adjustment knobs FIG. 41 and any
accessories loosened in step 4.
WARNING: Do not place the occupant on the Seating Module while seat adjustments knobs
are loosened. Make sure knobs are fully tightened before placing the occupant in the YoYo.
Seat Width
While user is seated on a flat surface, measure from hip to hip.
The user’s hip width should not be greater
than the width of the seat cushion.
FIG.43
15
FITTING GUIDE
While user is seated on a
flat surface, measure from
hip to hip. The user’s hip
width should not be greater
than the width of the seat
cushion.
Fig. 42
Seat Width
Fig. 42
Cable on the seating
system can be pulled
loose or dislodged during
transport and/or initial
assembly. Please check
the following cable
positions.
Check Tilt Adjustment Lever
1.Plug the cable end into the adjustment barrel.
2.Make sure the chrome cable end is fully seated inside
adjustment barrel.
Upper Propeller not
aligned at 90°
Upper Propeller not
aligned at 90°
Tilt cable out
of position
Tilt cable out
of position
Push In
Upper
Propeller
at 90°
alignment
FIG.41
FIG.42
FIG.43