Dinverter
A
User Guide
Issue code: d2au9
31
Power
connector
Signal
connectors
Termination
resistor
Gland plate
Cable-tying
point
Figure 4–5
Locations of the power and signal connectors, gland plate,
cable-tying point and termination resistor in the terminal
chamber of the Drive
Table 4–4
Connector sizes and data
Power connector
Signal connectors
Maximum wire size
2.5mm
2
(14AWG)
Use screwdriver type...
3mm (
1
/
8
in) flat-blade
Tightening-torque
0.5Nm (4.4 lb.in)
0.4Nm (3.5 lb.in)
2
When the Drive must meet IP20, fit three glands to the gland plate
when the Drive is to be used in Terminal mode; fit two glands when
the Drive is to be used in Keypad mode. (See
Methods of control
in
Chapter 1
Introduction
.)
3
When glands are used, refer to Figure 4–6.