CONTROL SOLUTIONS CS1171, Руководство пользователя

Страница: 36 / 56

CS1171 Hand-Held Programmer User's Manual
Control Solutions LLC Page 36 of 56
Parameter Description
Fast chgled A typical charging cycle will go through the following charging
modes in order:
1. Pre-charge,
2. Charge Qualification,
3. Bulk Charge,
4. Top-off Charge, and
5. Float.
The Fast chgled on/off setting determines when to flash the LED.
When set to On , flash will occur at the end of Bulk Charge mode.
When set to Off , flash will occur at the end of Top-off charge
mode.
Moment key When set to On , the system turns On and Off with a pushbutton or
momentary contact of the key switch. When set to Off , the unit
remains powered up only while the key switch remains closed, and
powers down when the key switch contact is opened.
Timed key When set to On , the unit will not power down immediately when
key switch state indicates power down, but remains on for the
duration defined by
Timeout . When set to Off , the unit powers
down as normal with no delays.
Accel drive Used to configure throttle for acceleration control, instead of speed
control. When set to
Off , the controller interprets throttle as a
conventional speed adjustment, where the direction and speed of
the unit is determined by the displacement from center and the
magnitude of the displacement. When set to
On , a throttle
displacement indicates acceleration to the controller. The unit
accelerates proportional to this displacement, as long as it is
present. Deceleration requires an equal and opposite
displacement.
FWD/REV input controls direction while Accel drive
is On , which results in a hard stop when toggling direction.
Tht lmt bst When set to On , motor compensation (boost) is limited by the
absolute throttle position.
Acl lmt bst When set to On , motor compensation (boost) is limited by the
acceleration of the throttle position (change in throttle over time).
Soft decel When set to On , negative (decelerating) boost is not applied,
resulting in a soft deceleration.
Qstop hi Depending on the module configuration quickstop can be wired as
active (+5 V) or passive (GND). In a passive configuration:

When the parameter is On , quickstop is asserted when active.

When the parameter is Off , quickstop is asserted when the
circuit is closed.