User's Manual
CS1171 Hand-Held Programmer
Page 33 of 56
Control Solutions LLC
Parameter
Description
Seq chrg led
When set to
On
, cycles the battery status LEDs from the bottom
segment to the top segment, with
charge complete
status
indicated by flashing the top segment. Setting
Seq chrg led
to
Off
disables this feature. The display type used, determines how this
option indicates a charge complete status.
Save boost
When set to
On
, saves real-time motor compensation (boost)
values and automatically reapplies them when stopping and
restarting on an incline to prevent rollback. Boost values are not
saved through a key switch power cycle.
Flash qstop
When set to
On
, while asserting a Quickstop, flashes the status
LED on the controller at a constant 2Hz rate. If equipped with a
display unit, also flashes the battery LEDs.
Fail dbstrt
When set to
On
or
Off
, it allows the status LED to display the
appropriate error code.
Fail qstop
When set to
On
, with Quickstop asserted, allows the status LED to
display the appropriate error code.
Serial throt
When set to
On
, configures the controller to respond to throttle
from an Enhanced Deluxe Display.
Analog throt
When set to
On
, configures the controller to respond to an analog
throttle directly connected to
TPOTC
input.
Sertht throt
When set to
On
, configures the controller to respond to the speed
control pot from an Enhanced Deluxe Display as a throttle.
Invrt sertht
When set to
On
while
Sertht throt
is enabled, inverts the
operation of the response to the speed control.
Rollbck A
Speeds up the activation of the EM brake when stopping on an
incline. It should be set low enough for acceptable stopping
performance on a nominal incline, but should not be set so low
that the brake prematurely engages when stopping on flat ground
or grass.
Double pull
When set to
On
, makes it necessary to activate the throttle
mechanism twice to make the vehicle drive.
An intelligent display with the ability to visually
represent real time data is required to use
Seq
chrg led
.
Содержание CS1171
Страница 1: ...Hand Held Programmer Document Number 000434A Revision B ...
Страница 56: ...Registered to ISO 9001 NSF ...
