8
3.6 Adding Additional Sensor Devices
To fulfill the need of tighter security control, you may need more
sensors than provided in a standard package. In order to integrate the
newly bought detector to your existing security system, the control
unit must know the transmit code of the new detector. Here is how to
tell the Control Unit what the transmit code is:
a.
Set the control unit to Setting Transmitter Code Mode by
keying in “Pass Code (0000) + # + 9”.
b.
Key in the 8-digit transmitting code, which is printed on
the ID Code Label of the sensor device. Press “#” when
you finished entering the 8 number code. See the example
on the following page of how to read the ID Code Label.
ID Code Label
1
2 3 4 5 6 7 8
0
1
2
3
4
5
6
7
8
9
The transmitting code for the above ID Code Label is:
4 0 9 2 6 3 6 1
c.
If you find you have input wrong code before you press
the “#”, immediately start entering from the first number
of the code input the code again. The unit will accept only
the last eight numbers as the input code.
d.
The unit checks the input code format automatically and
makes an “OK” beeping, if the format of the input code is
correct. Otherwise, it will give you a “Bad” beep.
e.
Use remote to control the unit, trigger the D/W and PIR
detector to send an alarm.
Formula: Pass Code (0000) + # + 9 + 8 digit Transmitter Code + #
To Delete all transmitter codes.
a.
Set the control unit to setting transmitter code mode as instructed
by keying in “Pass Code (0000) + # + 9”.
b.
Press the star key “*” 8 times, then “#’’. The unit will delete all
transmit codes saved in the unit.
Formula: Pass Code (0000) + # + 9 + “*” key eight times
4. Operating Your MA-D Security System:
The MA-D security system has been designed to be simple to
understand and easy to use. It should offer years of convenient, hassle
free security.
4.1 Program Mode:
In order to change the settings of the MA-D Control Unit you first
need to put it into the Program Mode. You do this by entering in your
pass code and pressing the # key. This will turn on the program LED.
You are now ready to make changes to your system.
Formula: Pass Code (0000) + #
4.2 Changing your "PASS CODE" ID:
To change your "User ID code, (password code), enter the existing
password code (it comes factory set with a password code of "0000"),
followed by the "#" key. This brings the alarm into Program mode.
