finishing
EN
46
W415-1283 / F / 04.30.18
glass media installation
Evenly spread the glass media onto the media tray, covering the burner tube and tray. Ensure no glass
media falls into the pilot opening. If this happens, insert a clean bag into your vacuum cleaner and vacuum
out the glass media. Replacement glass can be purchased from your local dealer / distributor.
Cleaning Glass Media
Glass media may have a fine oil residue that needs to be cleaned prior to installation. Clean the glass with
mild dish soap, drain, rinse thoroughly and dry before placing over the burner.
CBHD4STG AND CBHD4PG ONLY
MEDIA TRAY
PILOT MESH
logo placement
1/2”
(13mm)
1/2” (13mm)
LOGO
• Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
• Do not change or substitute the glass media material provided with this appliance. If replacing, use only the
replacement glass media available from your local authorized dealer / distributor.
• Glass media over the burner must not be more than one layer high. More than one layer over the burner will
cause flame lifting and sooting problems.
• Do not place any media (glass or vermiculite) in or around the pilot opening and/or on the burner ports. This
will interfere with the pilot operation.
Do not use more media than what was supplied with the appliance.
Glass media may cover the entire media tray. Care should be taken around the pilot mesh. We recommend that
no media should be placed directly on the pilot mesh.
note:
note:
!
WARNING