35
W415-1283 / F / 04.30.18
finishing
shipping bracket
A.
Remove the door(s), refer to "door removal / installation " section for instructions.
B.
Cut the strap holding the glass and vent thimble in place.
C.
Remove the 2 screws holding the shipping bracket / vent shield in place, as shown.
main safety barrier removal / installation
A barrier designed to reduce the risk of burns from the hot viewing glass is provided with the
appliance and shall be installed.
Before the glass door can be removed, the safety barrier must be removed. Lift the safety barrier up and pull it
out of the bottom retainer. Pull the safety barrier down and out of the top retainer.
Reverse these steps to reinstall the safety screen. Ensure it is installed correctly.
The two screws removed from the shipping bracket vent shield
MUST
be replaced.
note:
10.0 finishing
Risk of fire!
Never obstruct the front opening of the appliance.
The front of the appliance must be finished with any non-combustible materials such as brick, marble, granite,
etc., provided that these materials do not go below the specified dimension, as illustrated.
Do not strike, slam, or scratch. Do not operate appliance with glass removed, cracked, or scratched.
Facing and/or finishing material must never overhang into the appliance opening.
The glass door assembly is designed to pivot forward when relieving excess pressure that might occur. Finishing
or other materials must not be located in the opening surrounding the door as this will interfere with the doors
ability to relieve pressure.
•
•
•
•
•
•
!
WARNING
EN
